![]() ![]() Am i missing something?īelow a small part of the panel.cfg that I use because of copyright reasons. I think iam configuring the switch correctly as it "greys" out like the manual says it should.Īlso the same with the Master caution switch, Does nothing in my PMDG. Any one any ideas?įSUIPC says its connected, the bodnar boards are there and so is the phidgets board. It's as if prosim cannot see what state my PMDG overhead is in? completley stumped by this one. yet if i configure the same switch in prosim to drop the landing gear, it works, no problem. When i configure the switch, and try it nothing hapens. then did the same with the phidgets software, turned the flyboys off, and configured with prosim. i located the correct bodnar board and port number, and configured the switch through prosim. So off i went to the hangar (shed) and tested a just one switch through prosim. This was the best option to use, untill ofcourse prosim arrived! The LEDS are run my phidgets LED 64 using flyboys software. The overhead is run on 2 bodnar cards programmed using the FSUIPC buttons and switches macros. ![]() I have recently completed my overhead part of my cockpit project. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |